Samson EXPEDITION XP208w Manual Del Propietário página 11

Quick Start
XPD2 Wireless Microphone
1. Plug the RXD2 USB receiver into one of
the USB jacks on rear panel of the XP208w
directly (figure 1) or using the included USB
extension cable (figure 2).
2.
Place a fresh set of AA (LR6) batteries in
the transmitter battery holder, taking care to
observe the polarity markings.
3. Turn the Channel 3 Wireless Volume knob
completely counterclockwise, then turn the
power of the XP208w to the ON position.
4. Turn on the power to the HXD1 handheld
transmitter by pressing and holding Power
switch; the indicator LED will light amber.
5. If the transmitter and receiver have not been
previously paired, press and hold the button
on the RXD2 receiver for >5 seconds, until it
begins to flash. Press and continue to hold
the Power button on the transmitter until the
LED indicators on both units light steady,
indicating that the receiver and transmitter are
paired and ready for operation.
6. Speak or sing into the microphone at a normal
performance level and raise the Channel 3
Wireless Volume knob on the XP208w until
the desired level is reached.
7. If you hear distortion turn down the Channel 3
Wireless Volume on the XP208w. If distortion
is still audible, use the supplied screwdriver to
turn the Gain control in the HXD1 transmitter
slowly counterclockwise until the distortion
disappears.
Conversely, if you hear a weak, noisy signal
at the desired volume level and with the
Wireless level control of the XP208w is set
to maximum, use the screwdriver to turn
the Gain control in the HXD1 transmitter
slowly clockwise until the signal reaches an
acceptable level.
XP208w • Portable PA System
Figure 1
Figure 2
11