Samson EXPEDITION XP208w Manual Del Propietário página 9

Quick Start
1. Set the XP208w power switch to the OFF
position, and fully turn all of the LEVEL
controls counterclockwise to 0.
2. If an outlet is available, connect the included
power cord to the AC input of the speaker,
and plug it into an electrical outlet.
3.
Set the XP208w power switch to the ON
position.
4. Connect your audio sources.
5. Turn the MASTER VOLUME control up and
set the input levels, following the steps
below.
Making Connections
Channel 1 (Microphone / Line Input)
1. Connect a microphone using a standard XLR
cable or line level equipment using a 1⁄4"
instrument cable.
2. If connecting a microphone, set the LINE
/ MIC switch to the down (MIC) position. If
connecting a line level device, set the LINE /
MIC switch to the up (LINE) position.
3.
While speaking into the microphone or
playing music from a line level audio source,
slowly raise the channel CH1 VOLUME
control until you have reached the desired
level.
NOTE: If not using the Channel 1 input, turn the
VOLUME control all the way down to keep out
any unwanted noise.
Channel 2
Connecting an electric guitar (INST Input)
1. Connect an electric guitar using a standard
1/4" instrument cable.
2. Push the LINE/INST switch to the INST
(down) position.
3. While playing the guitar, slowly raise the
channel CH2 VOLUME control until you have
reached the desired level.
Note: If connecting an electric guitar it is
recommended to use a preamp between the
instrument and XP208w to replicate the
sound of a guitar amplifier.
XP208w • Portable PA System 9