Jole i-Trillo FX Manual De Instrucciones página 8

!
Pull the vehicle safety belt and pass through the belt path
, and then buckle it up.
21
21
1
2
!
Could also be installed by
using 3-point belt only.
!
Position shoulder belt through
the shoulder belt guide
shown in -1
21
!
DO NOT position vehicle belt
over top of the armrests. It
must pass underneath the
armrests. -2
21
!
The booster can not be used if
the vehicle safety belt buckle
(female buckle end) is too long
to anchor the booster securely.
-4
21
!
After your child is placed in this
booster, the safety belt must
be used correctly, and ensure
that any lap strap is worn low
down, so that the pelvis is
firmly engaged.
21
13
-3
21
3
4
-
21 25
!
To ensure the correct head
support height is obtained, the
bottom of the headrest MUST
be even with the top of child's
shoulders as shown in
22
the shoulder belt must be
positioned in the green zone as
shown in
23
!
Place a booster firmly against
the back of a forward-facing
vehicle seat equipped with a
lap/shoulder belt.
!
Make sure, that the shoulder
belt portion of the vehicle belt
goes straight through the
shoulder belt guide as shown
in
24
!
Tighten the vehicle belt by
pulling the shoulder strap until
all belt slack is removed.
!
I f the belt lays across child
neck, head or face, readjust
head support height.
!
Any straps holding the booster
to the vehicle should be tight
and the straps should not be
twisted.
22
and
23
24
25
14