Olimpia splendid CALDO UP T WIFI Instrucciones Para El Uso Y El Mantenimiento página 33

3.4 - FUNCTIONING
3.4.a - Fan mode
While using this mode, the appliance doesn't exert any action neither on temperature
nor on air humidity in the room. When pressing the ON/OFF
starts in this mode. The FAN LED on the appliance display turns on.
3.4.b - Minimum power heating mode
With the appliance on in fan mode, press key
In addition to the FAN LED, the LOW LED also switches on on the appliance display.
3.4.c - Maximum power heating mode
With the appliance on in minimum power mode, press key
maximum heating power. In addition to the FAN LED, the HIGH LED also switches on
the appliance display (and the LOW LED switches off).
It is also possible to activate this mode through the START/STOP button on
the back of the appliance (pos. 12 - figure X).
Press button START/STOP again and the unit switches to STAND-BY mode
(and switching off occurs as described in the next paragraph).
If one of the heating modes has been activated, press the ON/OFF
to turn the appliance off, the FAN LED starts flashing and the display starts
the 30 seconds countdown after which the appliance turns off (as well as the
FAN LED).
3.4.d - ECO mode (temperature setting)
Ambient temperature is shown on the display when the appliance is turned on.
When the appliance is on, pressing button
flash and the set temperature value to be shown.
Within 5 seconds, press buttons
18°C÷45°C - 1°C variations). To confirm the setting, please wait 5 seconds; the display
goes back to show ambient temperature.
If the set temperature is slightly higher than the ambient one (+1÷2°C), the minimum
power heating function activates automatically (FAN and LOW LEDs turned on).
If the set temperature is greatly higher than the ambient one (>3°C), the maximum
power heating function activates automatically (FAN and HIGH LEDs turned on).
If the set temperature is lower than ambient temperature, the appliance ends heating
function, after 30 seconds the fan stops (LOW and HIGH LEDs flashing) and flap
oscillation stops (LED flashing).
The set temperature can be changed at any moment during functioning.
to activate the minimum heating power.
will cause the temperature value to
and to set the desired temperature (range:
CALDO UP T WIFI
button, the appliance
twice to activate the
button
EN - 13