Segway Ninebot KickScooter ES3 PLUS Manual Del Usuario página 10

11 Specifications
Item
Length × Width × Height
Dimensions
Folded: Length × Width × Height
Weight Net
Payload
Rider Recommended Age
Required Height
Max. Speed
Typical Range [1]
Max. Slope
Machine
Traversable Terrain
Parameters
Operating Temperature
Storage Temperature
IP Rating
Nominal Voltage
Max. Charging Voltage
Charging Temperature
Battery
Nominal Energy
Battery Management System
Number Of Batteries
Motor Nominal Power
Output Power
Input Voltage
Charger Output Voltage
Output Current
Duration of Charging
Shock Absorber
Brake Light
Features Atmosphere Light
Riding Modes
[1] Typical Range: tested while riding under full power, 75 kg (165 lb) load, 25°C (77°F), 60% of max. speed on average on pavement.
* Some of the factors that affect range include: speed, number of starts and stops, ambient temperature, etc.
16
ES3 PLUS
102 × 43 × 113 cm (40 × 17 × 45 in)
113 × 43 × 32 cm (45 × 17 × 13 in)
14 kg (30.9 lb)
25–100 kg (55–220 lb)
14+ years
120–200 cm (3'11 –6'6")
30 km/h (18.6 mph)
45 km (28 miles)
15%
asphalt/flat pavement; obstacles < 0.4 in (1 cm); gaps < 1.2 in (3 cm)
-10–40°C (14–104°F)
-20–50°C (-4–122°F)
IP54
36 VDC
42 VDC
0–40°C (32–104°F)
368 Wh
Over-heating, short circuit, over-current and over-charge protection
2
300 W
71 W
100–240 VAC
42 VDC
1.7 A
7 h
front & rear
LED rear light
Customizable colour
Speed limit mode, Standard mode and Sport mode
12 Certifications
This product is certified to ANSI/CAN/UL-2272 by CSA.
The batteries comply with UN/DOT 38.3.
The second battery pack complies with ANSI/UL 2271.
Federal Communications Commission (FCC) Compliance Statement for USA
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator & your body.
Cet équipement est conforme aux limites d'exposition aux radiations de la IC définies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre corps.
Industry Canada (IC) Compliance Statement for Canada
This device complies with Industry Canada license-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
17