Publicidad
Idiomas disponibles
Idiomas disponibles
6 Charging
Charging step tips
Charge port
Open the charge
WARNING
Do not connect the charger if the charge port or charge cable is wet. Do not charge or use your battery if it is damaged
or see trace of water.
Your KickScooter is fully charged when the LED on the charger changes from red (charging) to green (trickle charge).
Close the charge port cover when not charging.
7 Learning to Ride
Wear an approved helmet and other protective gear
to minimize any possible injury.
08
Insert the
port cover.
charge plug.
1. Power on the scooter and check the
indicator power level. Charge the scooter if
the battery level is low.
Close the charge
port cover when
finished.
2. Stand on the footrest with one foot and
push off with your foot to start gliding.
4. Slow down by releasing the throttle; stir the
brake handle thumb shifter quickly and
stamp the fender with foot at the same time
to trigger mechanical braking in order to
make a sharp brake.
WARNING
When braking rapidly, you risk serious injury due to loss of traction and falls. Maintain a moderate speed and look out
for potential hazards.
3. Put your other foot on the footrest to keep both feet
stable. Press the throttle on right hand to speed up
when you are balanced.
Note: For your safety, the motor will not engage
until the scooter reaches 1.9 mph
(3 km/h).
5. To turn, shift your body and turn the handle
slightly.
09
Publicidad
