Publicidad
Idiomas disponibles
Idiomas disponibles
3.2 Hanging Method
When hanging the unit, ensure a balance of the unit, check to ensure safety and lift up smoothly.
(1) Do not remove any packing materials.
(2) Hang the unit in packaged state with two wire ropes, as shown in Fig. 3.1.
(3)Hang the unit without wooden pallet, as shown in Fig.3.2.
Rope Position
Wire Rope
Circular Hole
Wire Rope
Square Hole
Do not apply excessive force on the square holes with forks or
other materials. The bottom of the unit may be deformed.
Do not push the bottom base by fork.
*
Do not use roller.
*
Do not apply excessive
force (both sides)
In case of transportation after unpacking, protect the unit with splints or cloth.
Check to ensure that no foreign matters left in the outdoor unit before installation and test run. Otherwise,
a fire, failure or personal injury , etc. may occur.
Wire Rope
Corrugated Paper Frame
Do not remove
corrugated paper frame
and plastic bands
Do not apply
any forces here.
(Both Sides)
Wooden Pallet
Carefully guide the sling belts through
both side slots of the wooden pallet.
Fig. 3.1 Hanging Work for Transportation
Corrugated Paper Frame
CORRECT
Do not remove
corrugated paper frame
and plastic bands
INCORRECT
Apply wire ropes
through circular holes
Fig. 3.2 Hanging Work without Wooden Pallet
Angle of wire rope
greater than 60°
Apply ropes on the splints
or corrugated paper with
thickness greater than
19/32in. (15mm).
Bottom corners: Attach four
19/32in. (15mm) thick cardboard
padding on both sides at this point
for protection.
Wire Rope
NOTE
WARNING
5
Angle of wire rope
greater than 60°
Apply rope on the splints or
corrugated paper with thickness
greater than 19/32in. (15mm)
Do not apply any
forces here.
(Both Sides)
Bottom corners: Attach four
19/32in. (15mm) thick
cardboard padding on both
sides at this point for protection.
Publicidad
