cecotec Cumbia POWER MATIC-CCINO Vaporissima Manual De Instrucciones página 22

ENGLISH
3. Place a glass or cup under the coffee spout and adjust the spout's height based on the
container's. Depending on the size of the container (height and width), you can remove
the drip tray as shown in figure 4.
4. Press the strong coffee (18) or mild coffee (19) button based on your preference.
5. The coffee button you press will light up, indicating the appliance is preparing coffee.
6. Once the machine goes back to standby mode, the coffee will be ready for drinking.
Tip
It is recommended to use the strong-coffee button to prepare an espresso. You can adjust the
amount of coffee for each button (see 'Adjusting the amount of coffee/hot water').
Warning
No self-cleaning will be carried out if the coffee machine is switched off for a short time. You
can toggle this function by following these steps if active, or activate it if deactive:
Step 1: remove the side cover.
Step 2: press the On/Off button until the device beeps.
Please note
Press the hot-water button to clean the inside of the machine before first use.
Filling up the water tank
When flashes, it indicates that the water tank has a low water level, and you should fill it up.
1. Lift the water tank by using the lid as a handle as shown in figure 5.
2. Rinse the water tank with drinking water, fill the tank to the Max mark, and place it back in
the machine. Make sure it is properly placed.
Please note
To prevent water from spilling out of the water tank and damaging the coffee machine, do not
fill up the tank if it is partially or fully inserted into the coffee machine. Fig. 6
Important:
Never fill up the water tank with hot water, lukewarm water, carbonated water, or any other
liquid that may damage the tank and the device.
Filling up the coffee-bean tank
If flashes, it indicates that you should fill up the coffee-bean tank:
1. Remove the coffee-bean tank cover.
2. Carefully put in the coffee beans.
3. Put the tank cover back on.
POWER MATIC-CCINO VAPORISSIMA
42
Important
Only fill up the coffee-bean tank with natural-roast coffee beans. The use of ground coffee,
instant coffee, caramelised coffee, or any other object could damage the appliance. Never use
unroasted coffee, high-roast coffee, or a blend of natural and high-roast coffee.
Preparing frothed milk for coffee
Because the steam's temperature is higher than the espresso's, you must get the coffee ready
before making the frothed milk. Otherwise, the coffee may get burnt.
1. Brew coffee in a large cup or glass.
2. Add the desired milk amount to another container.
3. Direct the steam nozzle towards the drip tray.
4. Press the steam button (21). The steam indicator light will flash. The appliance will start
heating up and emptying the waste water into the drip tray.
5. Once the steam indicator light stops flashing, place the milk container under the steam
nozzle and insert it about 3 cm deep into the container.
6. Press the steam button (21) again.
7. Move the container while the appliance is releasing steam.
8. Froth will start to appear once milk has reached the required temperature. Then, press
the steam button again to stop the steam output.
9. Use a damp cloth to clean the nozzle cover and the metallic tube (see section "Daily
cleaning of the appliance").
10. Pour the frothed milk into the previously brewed espresso.
11. You can now enjoy your coffee.
Hot water
The appliance can dispense hot water from the steam nozzle by pressing the hot-water
button (22). The hot-water button and indicator light will light up to indicate the appliance
is dispensing water. When the hot-water button and the indicator light turn off, the water is
ready. You can stop the function at any time by pressing the hot-water button (22) again.
Favourite function
You can use the favourite function to save the desired amount of mild or strong coffee.
1. Configure your favourite coffee setting.
a) Press and hold the favourite-function button (20) for 2 seconds. The mild-coffee (19) and
strong-coffee (18) buttons will start flashing and the favourite-function button (20) will
light up steady. Press your favourite coffee option, strong (18) for more ground coffee or
mild (19) for less ground coffee.
b) The appliance will start dispensing coffee. Press and hold the button (18 or 19) to set the
amount of water in your coffee and release the button to stop the water once the desired
amount is reached. The machine will beep twice, return to Standby mode, and save the
ENGLISH
POWER MATIC-CCINO VAPORISSIMA
43