Publicidad
Drill with no impact
Metal, wood or plastic can be drilled with
the tool using drill / accessory bit three
jaws chuck with an SDS adapter (NOT INCLUDED).
• To install the three jaws chuck, go as with any other SDS accessory
(page 7, drill / accessory Installation).
• Set the bit into the three jaws chuck until is stops and secure with
the chuck key tightening each one of the orifices alternatively.
WARNING
Never use the three jaws chuck with the selector
in the operation mode in the IMPACT positions (
Use of the Dust Guard
• Slide the dust guard over the bit before boring vertically
over the head. The dust guard will prevent dust from
falling over the tool and the operator when drilling
Overload Brake
The tool is built with an overload breaker that stops the
axis force (causing a rattling sound) if the accessory gets
stuck. If this happens:
• Turn off the tool immediately.
• Remove the stuck accessory.
• Turn On the tool.
8
ENGLISH
Start Up
,
,
).
Additional Information
•SDS accessories need freedom of movement inside the
chuck. This causes eccentricity when the tool is unloaded.
However, the accessory gets centered automatically during
the operation with no affectation the drilling precision.
• When the tool is new it requires 5 hours working to gain
its maximum efficiency.
• When using the tool in the drill or hammer drill mode
first, set the bit tip in the point where the orifice will be
bored and then press the switch.
Publicidad
