Makita EN424MP Manual De Instrucciones página 5

3. Align the plate on the pipe with the groove in
the wheels, and then attach the wheels to the pipe as
shown in the figure. Securely tighten the bolt to fix the
wheels.
4
Fig.4
► 1 . Pipe 2. Wheel 3. Plate 4. Bolt
NOTICE:
Be sure to attach the wheels so that the
plate is engaged with the wheels.
4.
Remove the cap from the attachment.
Fig.5
► 1 . Cap
1
2
3
1
5. Attach the attachment to the pipe so that the hole
on the pipe is aligned with the hole on the attachment.
Securely tighten the short bolt first, and then tighten the
long bolt to fix the pipe.
2
3
Fig.6
► 1 . Pipe 2. Bolt (short) 3. Bolt (long)
NOTE: When tightening the bolts, apply 4.0 - 6.0 N•m
as tightening torque.
Mounting the attachment pipe
CAUTION:
Always check that the attachment
pipe is secured after installation. Improper instal-
lation may cause the attachment falling off from the
power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1. Remove the cap from the end of the pipe.
1
Fig.7
► 1 . Pipe 2. Cap
NOTICE:
Do not dispose of the cap since the cap
is necessary for storing the attachment.
5 ENGLISH
1
2