Publicidad
Idiomas disponibles
Idiomas disponibles
Operator's guide:
1)Unpacking instructions
2)The handles
3)Circular glass shelving
I
4)Grid shelves
5)Internal cleaning
UK
6)External cleaning
7)Connection to the mains
D
8)Controls
9)Checking correct operation
E
!
WARNINGS
F
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
NL
1. Adults should operate this appliance only. Do not allow children to use the controls or play with it. 2
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
P
installation of the appliance should be carried out by a qualified electrician or other competent person.
4
. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
S
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs.
6
7
. The manufacturers of this appliance accept no responsibility for the consequences of misuse in
DK
contravention of these safety instructions. It further reserves the right to carry out improvements without
prior notice.8
FIN
sources of heat, such as radiators, stoves, etc.
least 30 cm.
B
12
. If damp air or products to be refrigerated should cause ice to form on the evaporator, we recommend
stopping the compressor and placing the goods in special refrigerated containers, kept at the same
GR
temperature, until defrosting is completed;if this is not carried out the compressor will continue to operate
leading to a wasteful consumption of electricity and poor performance.
CZ
and unused, it is indispensable to keep the door open at least 10 cm. Avoiding this, you will avoid also the
consequent mildew formation and unpleasant smells.
EE
!
Our products are for internal use only – do not install outside restaurants, shops.
LV
1. UNPACKING INSTRUCTIONS
CARDBOARD BOXES 1a.
LT
WOODEN CRATES 1b.
between the appliance and pallet or crate. . Lift the appliance. . Remove the pallet or crate. . Place
H
the appliance on a flat, level surface. . Make sure there is nothing left in the package before disposing of
it.
7.
Sort out the packaging materials in order to facilitate disposal (see fig. 1).
M
2. THE HANDLES
1.
The handles can be found in a bag inside the appliance. . Fix the base of the handle using the two
screws already inserted in the holes on the door post; wrench down the screws.
PL
over the handle and press down until it clicks into place (see fig. 2).
3. CIRCULAR GLASS SHELVING
SK
1.
These shelves, which can be found in the cardboard box, should be slid into the supports on the
special posts. Fit the bottom mirror shelf first. . Secure the shelves in place using the screws you will find
SLO
in the bag, with the plastic part facing the glass. Tighten with care (see fig. 3).
4. GRID SHELVES
1.
You will find the shelves in a bag inside the appliance.
the slots on the posts
box, should be placed on the shelves, with the raised edge opposite to the doors (see fig. 4).
5. INTERNAL CLEANING
1.
Clean the internal surfaces and glass panels with a soft sponge and a neutral detergent.
soft dry cloth.
6. EXTERNAL CLEANING
1.
Use the same products as used for the internal cleaning. . Remove the protection from the steel parts
of the panel and grills (see fig. 5).
7. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. . Ensure that the supply socket:
rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA.
3
. Ensure that there is no danger of explosion (AD) in the room.
for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
N.B.:
If the equipment has been transported or stored overturned, let is rest in its correct position for at
least 3 hours before hooking it up to the mains. . Insert the plug in the socket (do not use three-way
adapters and reduction adapters) (see fig. 6).
5
. Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance near
11
.Ensure that the products displayed on the shelves and grills do not hang over the edges.
Cut surrounding tape. Remove the cardboard package by sliding it upwards.
Remove the nails from the wooden crate with care.
6
,
SNELLÉ 750 RBT
SNELLÉ 750 BTV and 400 BTV
,
(B)
and by pushing them downwards
2
Operator's guide
10)Internal cleaning
11)Replacement of internal light bulbs
12)Replacement of the door's magnetic gasket
13)Replacement of a glass panel
Maintenance manual (Page 48):
1)Cleaning the condenser
2)Cleaning the evaporator
3)Wiring diagram diagram of refrigeration unit
10
. Keep the ventilation grills free from obstruction for at
3
4
2
model
2
models
2.
Fasten the shelves, by putting their hooks in
(C). 3
. The grills, which are in the cardboard
2
a)
is properly earthed;
c)
complies with the IEC regulations:- thermal-magnetic
4.
5
6
3
9
13
. If the appliance is not working
2.
Insert forks of forklift truck
3.
Place the plastic insert
2.
b)
fulfils the requirements of the
Make sure the environment is suitable
. It
5
Wipe with a
(A)
attached
Publicidad
