Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
Prepare built-in oven
WARNING
Excessive Weight Hazard
Use two or more people to move and install an oven.
Failure to do so can result in back or other injury.
1.
Decide on the final location for the oven. Avoid drilling or cutting into house
wiring during installation.
2.
To avoid floor damage, set the oven on a cardboard prior to installation. Do
not use handle or any portion of the front frame for lifting.
3.
Remove the shipping materials and tape from the oven.
Remember to keep the packing materials that may be needed for installation.
4.
Remove the hardware package from inside of the bag containing literature.
5.
Remove racks and other parts from inside the oven.
Move oven and cardboard close to the oven's final location.
6.
8 English
Install_NQ5300R_NQ70R5511DG_AA_DG68-01149A-04_EN.indd 8
Remove and replace oven door
IMPORTANT: Use two hands to remove lower oven door. Upper oven door can't be
removed.
Prior to removing the oven door, prepare a surface where you will place it. This
surface should be flat and covered with a soft blanket, or use the corner posts
from your packaging material.
Remove lower oven door
1.
2.
A
B
A.
Oven door hinge lock in
locked position
B.
Oven door hinge lock in
unlocked position
3.
Open the oven door.
Locate the oven door hinge locks in
both corners of the oven door, and
then rotate the hinge locks toward the
oven door to the unlocked position (see
illustration B). If the door hinge lock
is not rotated fully, the door will not
remove properly.
Partially close the door to engage the
door latch locks.
The door will stop at this point.
11/11/2019 6:07:30 PM
Publicidad
