stayer SC241W Manual De Instrucciones página 48

3.Lower stationary guard 34.
4.Movable guard of the upper table 26.
Electrical protective equipment
1.Class II electrical insulation.
2.Protective module for electrical grid failures so as
to avoid fortuitous starts of a machine after
recovery after a cut off of the electrical supply.
17.General safety instructions
WARNING! When using electrical tools, the
essential safety precautions should always be
taken to reduce the risks of fire, electrical shock and
personal damages, including the following.
Read these instructions with attention before using
this product, and store them.
18.Regular cleaning,
maintenance and greasing
Cleaning
Clean the machine starting with a brush or with a flat
brush so as to remove sawdust and with a soft cloth.
If compressed air is available, complete cleaning by
blowing with the compressed air pistol.
Maintenance
After each 2,000 hours of use or each two years the
electrical tool must be sent to the official technical
service for maintenance and complete revision.
Before each use, check nuts and joints to detect any
vibration issues and use. If there are gaps take the
machine to service.
Except squeeze and brush change,
does not require any special maintenance by the
user. Keep the machine clean and use it correctly.
Regularly have the correctness of the adjustments
checked by a sufficiently trained user. In the case of
any failure, contact our technical service.
Changing brushes
IMAGES
Y Z
Warning!
Always use the brushes as supplied by the official
technical service.
1.Remove screw 48.
2.Remove lid 47.
3.Remove screw 50.
4.Move pressing spring 51 to the left.
5.Extract used 52 brush from the brush holder 49.
6.Insert new brush into the brush holder 49.
7.Place pressing spring 51 over the brush.
ENGLISH
37
8.After applying the brush connector tighten screw
50.
9.Position lid 47.
10.Tighten screw 48.
Greasing
This machine does not require any specific
greasing by the user. Specific greasing of the
electrical tool will be carried out on the occasion of
the regular maintenance revisions at the official
technical service.
1 9 . R e p a i r s e r v i c e o f t h e
manufacturer or commercial
agent:
Stayer Ibérica S.A. Área Empresarial de Andalucía
- Sector 1, Calle Sierra de Cazorla No. 7. Postal
code: 28320 Pinto (Madrid) Spain.
20.List of parts that may be
replaced by the user
IMAGES
1.Cutting disk 21.
2.Lower stationary guard 34.
3.Movable guard 26.
4.Brushes 52.
5.Guides for adjusting the cutting depth at the lower
table 41 .
6.Guides for adjusting the cutting depth at the lower
table 27.
21.Special tools as possibly
required
Tools as required are standard or included with the
accessories of the machine.
the machine
22.Safe operation
1.Keep working area clean. Unorderly working
areas and benches are susceptible of causing
damages.
2.Take into account the surroundings of the
working area. Do not expose tools to rain. Do not
use tools at humid or wet locations. Keep working
area well illuminated. Do not use tools in the
presence of inflammable liquids or gases.
3.Protect against electrical shocks. Avoid
contacts of the body with earthed or chassis-
earthed surfaces (e.g. pipes, radiators, heaters,
refrigerators, etc.).
4.Keep other persons away. Do not allow that
other persons, especially children, who are not
linked to the work, touch the tool or extensible
cables, and keep them away form the working
area.
37
Y Z