Publicidad
Idiomas disponibles
Idiomas disponibles
TRANSPORTATION AND PLACEMENT
When transporting the freezer, the inclination of the cabinet should not exceed 45 degrees,
for prevention against compressor or system damage.
Before use, remove all the packing material. The back side of the cabinet should be more
than 20cm away from the wall; both flank sides more than 20cm.
The freezer should be put in well-ventilated, dry place. Don't use it under direct sunshine.
The freezer should be kept away from water sink, heat source and any volatile, corrosive
material.
POWER SOURCE AND TEST-RUNNING
You can find the voltage and frequency of the freezer on the sticker located on the back.
Because of the possible variation in voltage (caused by overloading of circuits), we advise
you to use or install a separate circuit in order to eliminate the current variations avoid
engine problems. If the voltage is unstable, please install a voltage stabilizer with a capacity
of 1000W.
This device must be connected to an outlet with ground wire. This reduces the risk of electric
shock by providing an escape from the mains. This unit is equipped with a plug with ground
wire.
Plug the device directly into an outlet. Do not connect the freezer to extensions or plugs that
serve other appliances. Not amend the power cord.
Avoid turning on and off the power too frequently. If the power is turned off, wait an interval
of 5 minutes before turning it on again.
When the freezer will be out of use for a long time, disconnect the power first, and then clean
it. Please examine the circuit whether it is excellent before reuse.
DANGER: risk of children getting stuck in the freezer. Before you dispose of your freezer,
remove the door and the baskets in order to prevent children from entering the freezer and
get caught.
- 13 -
ENGLISH
Publicidad
