Tecfrigo NETTUNO Instalación Y Uso página 7

Operator's guide:
1)Unpacking instructions
2)Opening the protective plexiglass cover
3)Cleaning the inner tank
4)Cleaning the cover and external parts
5)The drip trays
6)The table
7)Connection to the mains
WARNINGS
(Page 45)
!
CAUTION: It is most important that this instruction booklet is kept together with the appliance
both for future reference and for reasons of safety.
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare 5
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. . The
manufacturers of this appliance accept no responsibility for the consequences of misuse in contravention
of these safety instructions. It further reserves the right to carry out improvements without prior notice.
8 . Avoid installing the cabinet directly in line with sunlight. . Never install the appliance near sources of
heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems, air
conditioning, etc ...). 10 . Keep the ventilation grills free from obstruction for at least 30 cm.
or products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until
defrosting is completed;if this is not carried out the compressor will continue to operate leading to a
wasteful consumption of electricity and poor performance.
1. UNPACKING INSTRUCTIONS
1a. Cut surrounding tape . Remove the cardboard package by sliding it upwards, remove the nails from
the wooden crate with care. . Lift the appliance, without putting pressure on the handgrip.
pallet or crate, thus disengaging the wheels of the appliance. . Make sure there is nothing left in the
package before disposing of it. . Sort out the packaging materials in order to facilitate disposal
(see picture 1)
2.
OPENING THE PROTECTIVE PLEXIGLASS COVER
1. Raise the cover by means of the handle on the right- or left-hand section. Grasp the handle, which is
located at the centre of each section, and guide the cover until it is fully open
3.
CLEANING THE INNER TANK
1
. Clean the tank using a soft sponge and neutral detergent. .Dry with a soft cloth (see picture 3)
4. CLEANING THE COVER AND EXTERNAL PARTS
1. Never use detergents containing alcohol or derivatives, or abrasive sponges and products, which
would irreparably damage the cover. . Use the same products as used for internal cleaning. . Use only
4
a soft wet sponge. . Use proprietary detergents especially designed for wooden surfaces, which are
water-based and do not contain solvents. . Dry with a soft clean cloth. . Remove the plastic film from
the grid on the motor compartment.
THE DRIP TRAYS
5.
1. The drip trays must be placed at the bottom of the tank (see picture 4).
6. THE TABLE
1. Grasp the outer edge of the table and pull it out by about 40 cm. It can be pulled out from both sides of
the trolley (see picture 4).
Operator's guide
2
5
2
5
7
8)Operations and adjustment
9)Internal cleaning and cleaning the evaporator
Maintenance manual (Page 45):
1)Cleaning the condenser
2)Cover replacement
3)Wiring diagram diagram of refrigeration unit
9
4
2
6
I
UK
D
E
F
NL
2
P
3
S
DK
7
FIN
B
11 .If damp air
GR
CZ
EE
LV
3. Remove the
LT
H
M
PL
SK
SLO
3