Publicidad
Idiomas disponibles
Idiomas disponibles
7.
CONNECTION TO THE MAINS
1. Ensure that mains voltage and frequency are the same as those stated on the rating plate (A) attached
to the appliance.
I
the rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate; - differential with Id sensitivity = 30 mA.
UK
3
. Ensure that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable
for the power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
D
5. Insert the plug in the socket (do not use three-way adapters and reduction adapters) (see picture 3)
E
8.
OPERATIONS AND ADJUSTMENT
The controls are located inside a protected recess on one side of the appliance.
F
(1) Thermometer for reading the temperature inside the appliance.
(2)Refrigeration switch: for turning on the refrigeration system.
NL
(3) Plug
4 "SET"
press key
or key
"6" DOWN
P
CAUTION: Before placing goods ensure that:
!
S
1.
the plug is connected; . the refrigeration unit switch is turned on (green light lit up); . internal lights
DK
are on;
4.
sliding panels and cover are closed; . thermometer shows the desired temperature for the
goods to be stored;
FIN
temperature does not exceed +30°C with 55% R.H. (climatic class 4).
B
INTERNAL CLEANING AND CLEANING THE EVAPORATOR (EVERY 15 DAYS)
9.
1.
Switch off the appliance. . Remove the refrigerated goods and place in a suitably refrigerated place.
3.
GR
Open the tap under the appliance.
tools to remove the ice.
bicarbonate and dry with care.
CZ
EE
!
Our products are for internal use only do not install outside restaurants, shops
LV
LT
H
M
PL
SK
SLO
Operator's guide
2
. Ensure that the supply socket:
once to display the temperature set-point, which can be changed by pressing key
(see picture 2)
2
6.
appliance is not exposed to direct sunlight or to powerful lamps; . ambient
2
4.
Leave the appliance to defrost. Do not use sharp or pointed metal
5.
Clean sides and accessories with a sponge dipped in water and a little sodium
is properly earthed;
a)
complies with the IEC regulations:- thermal-magnetic
c)
4
5
8
fulfils the requirements of
b)
"5" UP
3
7
Publicidad
