EDM Product 08760 Manual De Instrucciones página 26

Cordless angle grinder
Components
Rated voltage of battery
No load speed
Wheel size
Sound pressure level
Sound power level
Uncertainty
Vibration Level
Uncertainty
Operating Instructions
Before use
Remove any packing material and loose parts from unit.
Check the accessories before use. It should be fit with the
machine and your purpose. If the machine is new, the
battery must first be charged.
Attention! After long time storage, the battery capacity will
be reduce.
A new battery or one which has not been used for an
extended period achieves full performance only after
charging and discharging cycles. A substantial drop in
operating period per charge indicates that the battery is
worn out and must be replaced.
Battery charger (Fig.1)
The lithium-ion battery can be charged at any time and will
not develop a "memory" when charged after only a partial
discharge. It is not necessary to run down the battery pack
charge before recharging. Remove the battery pack from
the tool when convenient for you and your job. You can
"top-off" your battery pack's charge before starting a big job
or long period of use.
Due to lithium-ion's fade-free properties, the only time it is
necessary to charge the lithium-ion battery pack is when
the pack has reached the end of its charge. To signal the
end of charge, power to the tool will drop quickly. Charge
the battery pack as needed.
1. Charging the battery
This lithium-ion battery pack is shipped partially charged.
Before using it the first time, fully charge the battery pack. A
fully discharged battery pack with a temperature between
5°C and 40°C will charge in about 2 hours.
· Plug the charger adapter into power source. The green
light on the charger stand will illuminate, indicating the
EN INSTRUCTION MANUAL
Technical Specification
Only use 4.0Ah battery pack for this cordless angle grinder!
φ115 mm M14
LpA=76dB(A)
LwA=87dB(A)
a
charger is powered.
· Slide the battery all the way into the charger stand. The
green light is off, the red light on the charger stand will
illuminate, indicating that the battery is charging.
· The red light will go off after charging is complete and a
green light will appear.
NOTE: Batteries may become warm while charging. This is
normal. If the battery is hot after continuous use in the tool,
allow it to cool down to room temperature before charging.
This will extend the life of your batteries.
WARNING: Always disconnect the battery pack from the
tool before any assembly, adjustments or changing
accessories.
2. Insertion and removal of rechargeable battery (Fig.2)
Depress the battery-release button located on the front of
the battery pack to release battery pack. Pull the battery
pack out and remove it from the tool.
Warning!
Always remove the battery
adjustments to the equipment.
Be sure to read the following information before you put the
cordless equipment into operation: Charge the battery pack
with the charger. An empty battery pack requires a
charging period of approximately 1 to 2 hours for 4.0Ah
battery pack.
Fitting the auxiliary handle (Fig.3)
The auxiliary handle can be attached to the angle grinder in
3 different positions: left, right and top.
Disc guard (Fig.4)
CAUTION! The machine should be used only with guard.
The position of the disc guard can be adjusted to suite the
REF. 08760
20V DC
9500/min
K=3dB(A)
=9.108m/S
2
h
K = 1.5m/S
2
pack before making