en-us_main.book.book Page 45 Thursday, February 9, 2023 1:05 PM
Drying the Upper Oven Interior
The Drying function removes residual water inside
the steam generator. The function takes a little
over 1 minute and runs automatically after any
steam cooking cycle. The Drying function can also
be started manually, if needed.
Setting Drying
1
Make sure that the steam feeder tank is
empty.
2
Press UPPER More Modes and press 6.
3
Press START to begin Drying. The remaining
time appears in the display.
Periodic Maintenance
Changing the Oven Light
The oven light is a standard 25-watt halogen bulb
for ovens.
WARNING
• Make sure that the oven and bulb are cool.
• Disconnect the electrical power to the appliance
at the main fuse or circuit breaker panel. Failure
to do so can result in severe personal injury,
death, or electrical shock.
• Wear gloves while changing the oven light. Glass
fragments from broken bulbs can cause risk of
injury.
• Gently twist the screwdriver blade while
changing the oven light. If you apply force, the
glass or oven may crack.
1
Unplug the oven or disconnect power.
2
Remove the oven racks.
3
Slide a flat blade screwdriver
housing and the glass light cover
4
Support the glass light cover with two fingers
to prevent the cover from falling to the
bottom of the oven.
5
Gently twist the screwdriver blade to loosen
the glass light cover
6
Remove the bulb from the socket.
7
Replace the bulb, and reassemble the light
cover by snapping it back into place.
8
Plug in the oven or reconnect power.
between the
a
.
b
MAINTENANCE
45
.
c