LG WDEP9427 Serie Manual Del Propietário página 50

en-us_main.book.book Page 50 Thursday, February 9, 2023 1:05 PM
50 TROUBLESHOOTING
Parts & Features
Problem
Oven control beeps Electronic control has detected a fault condition.
and displays any F
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
code error.
The oven door is locked because the temperature inside the oven has not dropped
k is on in the display
below the locking temperature.
when you want to
cook
• Press the STOP button. Allow the oven to cool.
Oven light does not It is time to replace the bulb or the bulb is loose.
work.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner's Manual.
Cooling fan The fan turns off automatically when the electronic components have cooled
continues to run sufficiently.
after oven is turned
• This is normal.
off.
Oven will not Self The oven temperature is too high to set a Self Clean operation.
Clean.
• Allow the appliance to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if oven door is open.
• Close the oven door.
Oven door does not Oven is too hot.
open after a Self
• Allow the oven to cool below locking temperature.
Clean cycle
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
The oven is not clean Oven controls not properly set.
after a Self Clean
• See the Self Clean section.
cycle
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Convection fan stops Convection fan stops during a convection bake cycle. This allows for more even heating
(On some models) during the cycle.
• This is not a failure of the range and should be considered normal operation.
Displayed time is This means that the product has just been plugged in, or that it has experienced a
flashing (On some power interruption.
models)
• Press the Clock key and reset the time, or press any key to stop the flashing.
Oven racks are The shiny, silver-colored racks were cleaned in a Self Clean cycle.
difficult to slide (On
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
some models)
oven. If fault recurs, record fault number and call for service.
- [Case 1 ]
Code: F-9
Cause: Oven not heating (upper oven)
- [Case 2 ]
Code: F-19
Cause: Oven not heating (lower oven)
door can be opened when the lock
Self Clean again or for a longer period of time.
racks with the paper towel.
Possible Cause & Solution
k is no longer displayed.