Cherubini Ocean RX Instrucciones página 35

To enable (automatically) or disable (manually) the sun sensor refer to the instruction
manual provided with the sensor or the remote control you want to use.
This function is useful to check proper radio communications and to perform the wind
and sun function test.
To activate the TEST function, hold the SET button down for around 2 seconds, until
the awning opens for 10 seconds and closes briefly to confirm that the test has been
activated. The Test function lasts for 3 minutes, during which the wind and sunlight
threshold settings can be checked, without waiting for activation times. After 3 minutes,
the WindTec sensor returns to normal operational mode.
WIND FUNCTION TEST (WINDTEC, WINDTEC LUX)
To avoid errors during the wind function test, it is suggested that the sunlight function
be deactivated. By spinning the anemometer fins, when the speed detected by the sensor
exceeds the threshold set, the motor commands the closing of the awnings.
SUN FUNCTION TEST (WINDTEC LUX)
Make sure that the sunlight function is on. When the sensor detects a change in the
sunlight intensity, it opens the awning if the sunlight intensity goes above the threshold
set, or it closes the awning if the light intensity goes below the threshold set. It is possible
to repeat this test several times, so as to find the desired adjustment levels precisely.
ENABLE / DISABLE THE SUN SENSOR
(WindTec Lux)
TEST MODE
set
2 sec
(WINDTEC/WINDTEC LUX)
35