Toto TES201AB Serie Manual De Instalación Y Del Propietario página 10

[ 0.8 gallon (3L) Tank Type ]
Using the bracket to anchor the tank on the floor.
1. Anchor the tank and the brackets with the
decorative screws that should be tightened by
hand.
2. Install the tank on the floor with the screw.
Note
If the floor is made of concrete, embed the curl
plugs first.
[ 0.26 gallon (1L) Tank Type (special order)]
1. Anchor the bracket with the attached
round-head screw.
2. Pass the constricted part of the tank
between the bracket and insert it the full
depth.
3. Insert the tank in the slit on the bottom
surface of the bracket and pass it through
the two holes.
4. Attaching the bundling band.
* The bundling band serves to prevent the
tank from falling off if the tank collides
with something.
If the tank is installed behind a wall, etc., it
is not necessary to attach the bundling
band.
INSTALLATION PROCEDURE - Tank
Bracket
Two round-head
screws
(Φ 5.1 mm x 32 mm)
2. Insert it
the full depth.
3.
Slit on the bottom of
the bracket
10
Tank
2. Screw
1. Decorative screw
Wall surface
Bracket
Constricted part
Bracket
Hole
4. Bundling band