Toto TES201AB Serie Manual De Instalación Y Del Propietario página 18

After installation is complete, confirm that the dispenser is working properly using the following method.
Checking after the completion of installation.
After the installation has been compleated, test the product using the following procedure.
1. Shift the mode to the installation checking mode.
When your hand is held under the sensor for about
8 sec during the first 10 minutes after the power is
turned on, the mode shifts to the "Installation Mode".
During sensing, the liquid soap pump is driven and
the liquid soap continues to come out. (30 sec at
maximum)
The liquid soap stops when your hand leaves the
sensor.
Use this function for filling an empty flow path with
liquid soap.
Caution
 If more than 10 minutes pass since the power was turned on, pull out the power plug and insert it
again.
 When disconnecting and reconnecting the power plug , pull out the power plug and leave it
unplug for longer than 10 sec.
2. Dispense and stop the liquid soap.
 The liquid soap comes out when you bring
your hand under the sensor.
 The liquid soap stops when your hand
leaves the sensor.
3. Check the tank and the connection of the
liquid soap hose for any liquid soap leaks.
Caution
If the product is not used for a long period of time after installation, liquid soap remaining in the
hose dries and dispenses poorly. Therefore, conduct the trial run with water.
After the trial run, leave water accumulated in the tank as is and replace it with liquid soap at the
beginning of actual use.
TESTING
Checking for leaks
18
Sensor
Sensor