Publicidad
Idiomas disponibles
Idiomas disponibles
ENglish
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Blade Installation and Removal (Fig. E)
To Install a Blade
NoTE: This jig saw uses only T-shank jig saw blades.
NoTE: The DT2074 flush cutting blade is for use with
D
WALT DCS331, DW331 and DC330 jig saws only.
e
NoTE: When installing flush cutting blades (DT2074), the
anti-splinter insert must be removed and the shoe must to
be in the 0° positive stop position.
1. Lift the keyless blade release lever
Figure E.
Fig. E
5
11
12
11
32
2. Insert the T-shank blade into the clamp mechanism
3. The T-shank should be completely inside the clamp
4. Release the keyless blade release lever.
To Remove a Blade
1. Lift the keyless blade release lever
2. With a slight shake the blade will drop out.
Beveling the Shoe (Fig. F)
To unlock the shoe, pull the keyless bevel lever
the side.
To lock the shoe, push the keyless bevel lever back under
5
as shown in
the body of the jigsaw.
Fig. F
To Bevel the Shoe
1. Unlock the shoe.
2. Slide the shoe
3. The shoe can be beveled to the left or to the right
4. Once the desired bevel angle is achieved, lock the shoe
To Set Shoe Back to 0°
1. Unlock the shoe.
2. Rotate the shoe back to 0°.
while guiding the back of the blade into the groove of
the guide rollers
12
.
mechanism as shown in Figure E.
CAUTION: Do not touch used blades, they may be
hot. Personal injury may result.
6
7
forward to release it from the 0°
7
positive stop position.
and has detents at 15°, 30° and 45°. The shoe can be
manually stopped at any degree between 0° and 45°.
into place.
11
5
.
6
to
Publicidad
