Publicidad
◾
The declared vibration total value may also be used in
EN
a preliminary assessment of exposure.
NOTICE:
The vibration emission during actual use of the
power tool can differ from the declared value in which the
tool is used; In order to protect the operator, user should
wear gloves and ear protectors in the actual conditions
of use.
PACKING LIST
PART NAME
Hedge Trimmer Attachment
Wrench
Blade Scabbard
Operator's Manual
DESCRIPTION
KNOW YOUR HEDGE TRIMMER ATTACHMENT (Fig. A)
1. Cutting Blade
2. Quadrant
3. Trigger
4. Hedge Trimmer Shaft
5. End Cap
6. Adjusting Lever
7. Gear Case
8. Wrench
9. Blade Scabbard
10. Tip Protector (Optional, SOLD SEPARATELY)
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
hedge trimmer. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possibly serious personal injury.
WARNING:
Never attach or adjust any attachment
while the power head is running or with the battery
installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
ADJUSTING THE CUTTING BLADE
When the hedge trimmer is removed from the package,
8
HEDGE TRIMMER ATTACHMENT — HTA2000S
it is unfolded totally which the angle between the
blade and the hedge trimmer shaft is 180° (Fig. B). It is
recommended to adjust the cutting blade to a suitable
working position before attaching it to the power head.
There are 9 possible working positions. The angle of the
cutting blade can be adjusted upwards in 5 stages from
0° (straight) to 45°, including 0°, and downwards in 4
stages from 0° to 52° (right angle facing down) (Fig. C),
not including 0°.
1. Press the trigger on the adjusting lever and
meanwhile rotate the adjusting lever to adjust the
QUANTITY
cutting blade to the desired cutting position (Fig. D).
1
2. Once the desired position has been reached, release
1
the trigger. An audible click indicates that the locking
1
pin is engaged in the quadrant, right located into
place (Fig. D).
1
Fig. D parts description see below:
D-1 Quadrant
D-2 Locking Pin
WARNING:
out the adjustment only when the cutting blades are
at a standstill. Never touch the blades while making
adjustments.
WARNING:
the tool and fit the blade scabbard before moving the
cutting blade to the storage position or from the storage
position to the normal working position.
CONNECTING/REMOVING THE HEDGE TRIMMER
ATTACHMENT TO THE POWER HEAD
This hedge trimmer attachment is designed for use with
EGO 56V LITHIUM-ION Power Head PH1400E. Besides
top cutting, there is a side-cutting position in the hedge
trimmer shaft for connecting with the power head (Fig.
E). Detail working techniques please see "WORKING
TECHNIQUES" section in this manual.
Fig. E parts description see below:
E-1 Top Cut Position
E-2 Side Cut Position
See "INSTALLING AN ATTACHMENT TO THE POWER HEAD
" section in the power head PH1400E operator's manual for
connecting the hedge trimmer to the power head.
See "REMOVING THE ATTACHMENT FROM THE POWER
HEAD" section in the power head PH1400E operator's
manual to remove the hedge trimmer from the power head.
MOUNTING THE TIP PROTECTOR (Optional)
1. Use a hex wrench to remove the short bolt, plain
washer, bush and nut at the end of the cutting blade
To reduce the risk of injury, carry
To reduce the risk of injury, always stop
Publicidad
