Publicidad
Idiomas disponibles
Idiomas disponibles
CARE AND SERVICING OF YOUR ANDIS CLIPPER/TRIMMER
BLADES
Blades should be oiled before, during, and after each use. If your clipper/trimmer
blades leave streaks or slows down, it's a sure sign blades need oil. The clipper/
trimmer should be held in position shown in Figure C to prevent oil from getting
into motor. Place a few drops of Andis Clipper Oil on the front and side of the cutter
blades (Figure D). Wipe excess oil off blades with a soft, dry cloth. Spray lubricants
contain insufficient oil for good lubrication, but are an excellent clipper/trimmer
coolant. Always replace broken or nicked blades to prevent injury. You can clean the
excess hair from your blades by using a small brush or worn out tooth brush. To clean
the blades we suggest to immerse the blades only into a shallow pan of Andis Blade
Care Plus, while the clipper/trimmer is running. Any excess hair and dirt that has
accumulated between the blades should come out. After cleaning, turn your clipper/
trimmer off and dry blades with a soft, dry cloth and start clipping again.
REMOVAL OF BLADE SET
To remove the blades, first unplug the clipper/trimmer from the electrical outlet.
Hold the clipper/trimmer so that the blade teeth are pointing up. Press forward on
blade (Figure E).
REPLACEMENT OF BLADE SET
Align blade yoke armature pin in correct position before replacement of blade set
(Figure G). To replace the blade, line up the bottom hook of blade set with the slot on
the clipper/trimmer and snap into place (Figures F & G).
CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it
is advised to purchase a new set of blades available through your Andis supplier or
through an Andis authorized service station. If you wish your clipper/trimmer to be
serviced as well, it should be carefully packed and mailed either parcel post insured,
or U.P.S. to any Andis authorized service station.
CAUTION: Never handle your Andis clipper/trimmer while you are operating a
water faucet, and never hold your clipper under a water faucet or in water. There is
danger of electrical shock and damage to your clipper. Andis Company will not
be responsible in case of injury due to this carelessness.
6
Publicidad
