Features; Assembly - Ryobi BG612GSB Manual Del Operador

PRODUCT SPECIFICATIONS
Wheel Diameter ............................................................ 6 in.
Wheel Thickness .......................................................3/4 in.
Arbor Hole .................................................................1/2 in.
UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories
not recommended for use with this tool. Any such
alteration or modification is misuse and could result in a
hazardous condition leading to possible serious personal
injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.

FEATURES

No Load Speed .....................................3,600 r/min. (RPM)
Input ...................................................120 V~, 2.1 A, 60 Hz

ASSEMBLY

WARNING:
Always spin the wheel by hand before turning on the
grinder to make sure the spark deflector doesn't hit the
grinding wheel.
TOOLS NEEDED
See Figure 2, page 11.
The following tools (not included or drawn to scale) are
needed for assembly:
 Adjustable Wrench
 10 mm Wrench
 Phillips Screwdriver
LOOSE PARTS LIST
See Figure 3, page 12.
The following items are included with the tool:
Hex Head Bolt ............................................................ 2

Washer ....................................................................... 2

Clamp Bracket ........................................................... 2

Spark Deflector .......................................................... 2

 Flat Washer ................................................................ 2
Lock Washer .............................................................. 2

Phillips Head Screw ................................................... 2

Work Rest, Left .......................................................... 1

Work Rest Knob ......................................................... 2

Work Rest, Right ........................................................ 1

Carriage Bolt .............................................................. 2

 Shield Rod, Right ....................................................... 1
Shield Rod, Left .......................................................... 1

 Spark Shield ............................................................... 2
MOUNTING SPARK SHIELD ASSEMBLY
See Figures 4 and 5, page 12.
 Insert shield rod into spark shield as shown.
 Attach the spark shield assembly and bracket to the wheel
guard using a clamp bracket, washer, and hex head bolt.
 Using the 10 mm wrench, tighten bolt securely.
 Repeat above steps for the other side.
7 — English