Publicidad
Idiomas disponibles
Idiomas disponibles
Interior - after convection, mix or broil cooking
Spatters may occur because of moisture and grease. Wash immediately after
use with hot, soapy water. Rinse and polish dry. Harder to remove spatters
may occur if oven is not thoroughly cleaned or if there is long time/high
temperature cooking. If so, you may wish to purchase an oven cleaner pad
with liquid cleaner within it—not a soap filled steel pad—for use on stainless
or porcelain surfaces. Follow manufacturer's directions carefully and be
especially cautious not to get any of the liquid cleaner in the perforations on
the wall or ceiling or any door surfaces. Rinse thoroughly and polish dry.
After cleaning the interior thoroughly, residual grease may be removed
from the interior ducts and heater by simply operating the oven on 450˚F for
20 minutes without food. Ventilate the room if necessary.
Waveguide Cover
The waveguide cover is made from mica so requires special care. Keep the
waveguide cover clean to assure good microwave oven performance. Care-
fully wipe with a damp cloth any food spatters from the surface of the cover
immediately after they occur. Built-up splashes may overheat and cause smoke
or possibly catch fire. Do not remove the waveguide cover.
Odor Removal
Occasionally, a cooking odor may remain in the microwave oven. To remove,
combine 1 cup water, grated peel and juice of 1 lemon and several whole
cloves in a 2-cup glass measuring cup. Boil for several minutes using 100%
power. Allow to set in microwave oven until cool. Wipe interior with a soft
cloth.
Turntable/ Turntable Support/ Racks
The turntable, turntable support and racks can be removed for easy cleaning.
Wash them in mild, sudsy water; for stubborn stains use a mild cleanser and a
non-abrasive scouring sponge. They are also dishwasher-proof. Use top rack
of dishwasher for turntable support.
Foods with high acidity, such as tomatoes or lemons, will cause the porcelain
enamel turntable to discolor. Do not cook highly acidic foods directly on the
turntable; if spills occur, wipe up immediately.
The turntable motor shaft is not sealed, so excess water or spills should not be
allowed to stand in this area.
36
Publicidad
