Bosch NGM8056UC Manual Del Usuario página 6

IMPORTANT SAFETY INSTRUCTIONS
9
READ AND SAVE THESE INSTRUCTIONS
Safety Codes and Standards
This appliance complies with one or more of the
▯
following standards:
ANSI Z21.1- • CSA 1.1
Household Cooking Gas
Appliances
It is the responsibility of the owner and the installer to
▯
determine if additional requirements and/or standards
apply to specific installations.
Installation must conform with local codes or, in the
▯
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54 or, in Canada, the
Natural Gas and Propane Installation Code, CSA
B149.1.
The appliance must be electrically grounded in
▯
accordance with local codes or, in the absence of
local codes, with the National Electrical Code ANSI/
NFPA 70 or the Canadian Electric Code, CSA C22.1-
02.
State of California Proposition 65
Warning:
This product may contain a chemical known to
the State of California, which can cause cancer
or reproductive harm. Therefore, the packaging
of your product may bear the following label as
required by California:
6
Electric Safety
Before you plug in an electrical cord, be sure all
▯
controls are in the OFF position.
For appliances equipped with a cord and plug, do not
▯
cut or remove the ground prong. It must be plugged
into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether the
wall receptacle is properly grounded, the customer
should have it checked by a certified electrician.
This appliance should be installed in accordance with
▯
the National Electric Code or Canadian Electrical
Code. It is required that the cooktop be installed on a
grounded, non-GFCI branch circuit.
Installer-show the owner the location of the circuit
▯
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
▯
Lock service panel to prevent power from being turned
ON accidentally.
Be sure your appliance is properly installed and
▯
grounded by a certified technician. Installation,
electrical connections and grounding must comply
with all applicable codes.
High Altitude Installation
Contact customer service for use at altitudes above
2,000 feet (610 meters).