Publicidad
Idiomas disponibles
Idiomas disponibles
4.4
Mounting of the EcoFlex H
For mounting examples, refer to Fig. III on page
50.
For mounting on the wall or on a mounting structure:
•
proceed with paragraph 4.4.1
For mounting on a stanchion (PA):
•
proceed with paragraph 4.4.2
For mounting on an extension crane:
•
refer to the instruction sheet that is supplied with the
extension crane
•
subsequently: proceed with paragraph 4.4.3
4.4.1
Wall mounting
WARNING!
Before you install the product, make sure that the
wall or mounting structure is strong enough. Refer
to paragraph 1.5 for the weight of the product.
Refer to Fig. VI on page 52 for the dimensions
and mounting measurements of the wall bracket.
The package contains no mounting hardware for the wall
bracket, since the required mounting hardware depends on the
wall type. You can mount the wall bracket on e.g.:
A
a thin brick or concrete wall (min. thickness 100 mm), with
four threaded rods M10;
B
a thick brick or concrete wall, with four cotter bolts
M10x120x60;
C
a steel profile (e.g. H-profile), with four threaded rods
M10. For this purpose two square tubes (30x30x3 mm)
need to be mounted to prevent bending.
Fig. 4.1
•
Install the wall bracket to the wall or mounting structure.
Fig. 4.1
Mounting of the wall bracket
For mounting of the arm to the wall bracket:
•
proceed with paragraph 4.4.3
86958016
4.4.2
Mounting on a stanchion
The stanchions 1,1 and 2,2 m are suitable for several
mounting positions:
Mounting to/on
Floor
Ceiling
Wall
Recommended mounting hardware:
Mounting of:
Stanchion on concrete floor
Stanchion to the ceiling
Stanchion to the wall
Wall bracket to the
stanchion
Fig. 4.2
•
Determine the position of the stanchion.
•
Install the mounting plate accordingly.
•
Install the wall bracket to the stanchion.
Refer to Fig. V on page 51 for detailed mounting
instructions of:
- the mounting plate to the stanchion
- the wall bracket to the mounting plate
•
Install the stanchion to the floor, wall or ceiling.
Floor mounting
Ceiling mounting
Fig. 4.2 Stanchion (PA)
For mounting of the arm to the wall bracket:
•
proceed with paragraph 4.4.3
4.4.3
Arm mounting
TIP
Do a balance check of the arm before you fasten the
hose. Refer to paragraph 6.2.
Fig. 4.3
•
Remove the locknut M20 (A) from the hinge rod (E).
•
Put the hose tube over the internal rods of the arm.
•
Move the hose clamp (F) and the arm swivel ring (incl.
rubber collar) (D) over the hinge rod (E).
•
Put the washer M20 (C) on the arm swivel ring (D).
•
Put the hinge rod (E) in the rotating flange (B).
Position
vertical
horizontal
Hardware:
Anchor bolts
Anchor bolts
Depends on the wall type (also
refer to paragraph 4.4.1)
4x bolt M12x30 with
4x locknut M12
Wall mounting
EN | 5
Publicidad
