Publicidad
Idiomas disponibles
Idiomas disponibles
6
MAINTENANCE
6.1
Periodic maintenance
The product has been designed to function without
problems for a long time with a minimum of
maintenance. In order to guarantee this some simple, regular
maintenance and cleaning activities are required which are
described in this chapter. If you observe the necessary caution
and carry out the maintenance at regular intervals, any
problems occurring will be detected and corrected before they
lead to a total breakdown.
WARNING!
Overdue maintenance can cause fire.
The indicated maintenance intervals can vary depending on
the specific working and ambient conditions. Therefore we
recommend to thoroughly inspect the complete product once
every year beside the indicated periodic maintenance. For this
purpose contact your supplier.
Component
Action
Hose tube
Check for cracks or damages. Replace
if necessary
Hood
Check the movement of the hood. If
necessary, adjust the friction; refer to
paragraph 6.2
Arm
Check horizontal, vertical and
movement
diagonal arm movement. If
necessary, adjust the friction; refer to
paragraph 6.2
6.2
Arm adjustment
If the extraction arm, or a part of it, does not stay in the
desired position, you must adjust the friction.
Fig. 6.1
•
Determine which joint needs more or less friction.
•
Loosen the hose tube to get access to the hinges.
•
Pull the arm in a horizontal position.
•
Adjust the friction; refer to the images below for the
adjustment points.
Swivel bracket
17
"H" types
86958016
Frequency:
every X
months
X=3
X=6
X
X
X
17
"S" types
Middle hinge
Hood hinge
10
Fig. 6.1 Adjustment points
TROUBLESHOOTING
7
If the product does not function (correctly), consult
the checklist below to see if you can remedy the
error yourself. Should this not be possible, contact
your supplier.
WARNING!
Obey the safety regulations that are written in
chapter 3 when you carry out the activities below.
Symptom
Problem
The
Escape of
extraction
fume; no
arm does not
proper
stay in the
extraction
desired
position
You cannot
get the arm
in the desired
position
8
SPARE PARTS
The following spare parts are available for the
product;
- refer to exploded view Fig. VII on page 53
DISPOSAL
9
After life of the product, dispose of it in accordance
with federal, state or local regulations.
17
Possible
Solution
cause
Friction setting
Adjust the friction;
is not correct
refer to Fig. 6.1 for
the adjustment
points
EN | 8
Publicidad
