Publicidad
Idiomas disponibles
Idiomas disponibles
•
Put the hose (G) over the arm swivel ring (D).
•
Use the rubber collar to make the connection airtight.
•
Attach the hose (G) to the swivel ring (D) with the hose
clamp (F).
•
Put the locknut M20 (A) on the hinge rod (E) and tighten it.
•
Install the assembly to the wall bracket with the 8 bolts
M6x25 + washers M6.
B
D
F
G
Fig. 4.3 Mounting of the arm
For mounting of the hood:
•
refer to paragraph 4.6
4.4.4
Fan mounting
To install an extraction fan
Fig. 4.4
•
Put the fan on the wall bracket.
•
Insert 4 bolts M6x25
through the bottom of the wall
5
bracket into the cage nuts of the fan housing.
•
Fasten the bolts securely.
Fig. 4.4 Mounting of the fan
3.
Suitable types: refer to paragraph 1.4
4.
The bolts are supplied with the arm
86958016
A
B
C
D
E
F
G
on the arm, do the following.
4
4.5
Mounting of the EcoFlex S
For mounting examples, refer to Fig. IV on page
50.
For mounting on a stanchion (PA):
•
proceed with paragraph 4.5.1
For mounting on a wall bracket:
•
proceed with paragraph 4.5.2
For mounting on a mobile unit:
•
proceed with paragraph 4.5.3
4.5.1
EcoFlex S on a stanchion
Fig. 4.5
•
Disassemble the rotating flange from the wall bracket and
change the position from bottom to top.
Fig. 4.5 Position of the rotating flange
For mounting of the wall bracket to the stanchion:
•
proceed with paragraph 4.4.2
•
subsequently: proceed with the instructions of Fig. 4.7
(paragraph 4.5.3)
4.5.2
EcoFlex S on a wall bracket
For mounting of the arm to a wall bracket:
•
proceed with the instructions of Fig. 4.5 (paragraph
4.5.1)
•
subsequently: proceed with the instructions of Fig. 4.7
(paragraph 4.5.3)
4.5.3
EcoFlex S on a mobile unit
TIP
Do a balance check of the arm before you fasten the
hose. Refer to paragraph 6.2.
Fig. 4.6
•
Install the rotating flange (C) on the filter unit with the 8
bolts M6x25 (A) + washers M6 (B).
Fig. 4.6 Rotating flange
EN | 6
Publicidad
