Kalorik PCM 42472 Manual página 8

Do not operate for more than 5 minutes consecutively per batch.
Overheating will affect performance and damage the product.
PARTS DESCRIPTION
See page 2-3.
BEFORE FIRST USE
Before first use, lift the lid off and wipe clean the inside of the unit

with a non-abrasive, slightly damp sponge or towel, then wipe dry

Put the lid back on the base
OPERATING INSTRUCTIONS
Warning! Never add butter, salt. oil or sugar to the corn in the popping
chamber!
Only use corn especially made for popping.

Make sure the appliance is unplugged and switched off, and fully

assembled.
Measure popping corn using the corn measuring cap. One full

measure per popping session is enough (approx. 60g). More than
one full measure could overfill the appliance and disturb the
correct functioning of the appliance. Less than one full measure
could cause fewer kernels to pop and more un-popped kernels to
be ejected from the chute.
Pour corn into the popping chamber through the filling inlet of the

lid. Do not add anything else other than corn kernels.
Put the measuring cap back on top of the lid.

Select a bowl with at least 3L / 12 cup capacity, that is heat

resistant and will fit under the chute (but not block it)
Place this bowl under the chute so that the edge of the bowl is

touching the body of the machine. It is important that the popcorn
www.KALORIK.com
.
8
PCM 42472 - 170120