Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC FUNCTIONS
Switching the set on and off
Set the POWER control to the desired sound source:
CD, TAPE, or BAND (for radio).
The set is switched off when the POWER control is set to
O O F F F F
/TAPE and the keys of the tape deck are released.
Note: If you use batteries, switch the set off after use. This will
avoid unnecessary power consumption.
Adjusting volume and sound
Adjust the volume using the VOLUME control.
Increase and decrease the bass level by pressing DBB.
The bass level can also be emphasized if you place the set against
a wall or shelf. Do not cover any vents; leave sufficient room
around the unit for ventilation.
Radio – tuning to radio stations
1 Set the POWER control to FM or AM to select the desired
wave band.
2 Tune to the desired radio station by using the TUNING wheel.
Improving RADIO reception
For FM stations, pull out the telescopic antenna. To improve the
signal, incline and turn the antenna. Reduce its length if the signal
is too strong (very close to a transmitter).
For AM stations, direct the internal antenna by turning the whole
set. The telescopic antenna is not needed.
8
RADIO
V
V
Publicidad
