Serta Motion Essentials VI Guía De Configuración Rápida página 3

STEP 3
To sync two bases with the Sync Cord, see installation
instructions in Owner's Manual
Locate the battery backup strap.
Store the battery backup strap in a
convenient location for emergency use.
For operating instructions, see owner's
manual.
STEP 4
Uncoil input cord (connected to control
box's power port) and plug it into Power
Supply.
STEP 5
Uncoil Power Cord and connect to Power
Supply. Place Power Supply on ground
and extend from base. Ensure that Power
Supply and all attached cords are directed
toward the desired surge protector.
STEP 6
Carefully flip the base over onto its legs.
Important: Two people are required to move the bed base. Do
not drag frame across the floor or rest frame on its side, as excessive
pressure may damage the legs.
Head Up/Down
Flat Position
STEP 7
Plug the base into a power source. A surge protector is strongly
recommended. Unauthorized modification or failure to use a wall
outlet or surge protector could void the electrical portion of your
warranty.
STEP 8
Install (3) AAA batteries in remote control.
Test functions before placing mattress on base to
verify proper setup.
Press FLAT to return base to a flat position.
STEP 9
Insert each end of the mattress retainer bar into the holes at the foot
of the base. Make sure the bar is secured.
For customer support, visit www.ergomotion.com or call:
REMOTE OVERVIEW
CHILD SAFETY LOCK
Activate Child Lock
Foot Up/Down
Deactivate Child Lock
Zero-G®
Position
Setup is now complete!
For more information please see Owner's Manual.
1-888-550-3746
To activate Child Lock, press and hold the HEAD
UP and FOOT UP buttons together for three (3)
seconds until the remote backlight flashes twice.
The remote is now in Child Lock. Pressing any
buttons while in Child Lock will yield no
movement to your adjustable base.
Press and hold the HEAD DOWN and FOOT
DOWN buttons together for three (3) seconds,
then hold HEAD UP and FOOT UP for three (3)
seconds until the remote backlight flashes twice.
The remote is no longer in Child Lock. The
remote and adjustable base will work normally.