Vortice 12101 Manual De Instrucciones página 37

ENGLISH
CONTROL PANEL FUNCTIONS
Upon start-up, the display shows the Vortice logo for about 10
seconds and then the set operating speed before the last shut-
down.
Note: In general, in the absence of user input, after two minutes
the display will return to the logo screen without saving any
changes. In this case, press
In this phase, you can immediately increase the speed to the maximum value (OFF, 1, 2, 3, BOOST) via the button
to decrease from BOOST, 3, 2, 1, OFF).
1
You can change the type of data shown on the bottom of the display by using the buttons
:
2
13 / 01 / 18
Date/time and Prog if weekly programming is active and
Man if speed was changed manually during weekly
programming.
to reactivate the home screen.
Prog
08:07
2
13 / 01 / 18
2
:
2
08:07
and
2
(
37