Resetting The Spotlight To Its Factory Settings; Cleaning The Spotlight; Specifications - IMG STAGELINE ODC-100/RGB Manual De Instrucciones

5.4 Resetting the spotlight
to its factory settings
The factory settings of the spotlight are as fol-
lows:
Menu
Function
item
number of DMX channels
max. brightness
white balance function
subaddress function
slow LED response
subaddress
11 shades of white
white balance
DMX / independent mode
or slave mode
Fig. 13 Factory setting
To reset the spotlight to its factory settings:
1) Press the button MENU repeatedly until the
highest menu level has been reached .
2) Press the button UP or DOWN repeatedly until
the display indicates
3) Press the button ENTER . The display indicates
, , ,
4) Press the button UP or DOWN repeatedly until
the display indicates
5) Press the button ENTER so that the display
indicates four entry positions ( . . . .) . Then press
the following buttons:
UP, DOWN, UP, DOWN .
Each time one of these buttons is pressed, an
asterisk ( ) will appear on the display .
6) To reset the settings, press the button ENTER
(the display briefly indicates
the procedure, press the button MENU .
7) To be able to control the spotlight by DMX,
use the button MENU to return to the highest
menu level .
For independent operation, use the button
MENU to select the operating mode and then
press ENTER to activate the mode selected .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
Factory setting
= 10 channels
= 100 %
= slowest
01
factory settings
R = 255, G = 255,
B = 255
= DMX / inde-
pendent operation
.
, or .
.
) or, to cancel
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®

6 Cleaning the Spotlight

Clean the pane in front of the LED at regular inter-
vals depending on impurities . This is the only way
to ensure that light will be emitted at maximum
brightness . Before cleaning, disconnect the
mains plug from the socket. Only use a soft
clean cloth and a glass cleaner .
For cleaning the other parts of the housing of
the PARC-100 / RGB, only use a soft clean cloth .
Never use any fluid; it may leak into the spotlight
and damage it .
The weatherproof housing of the ODC-
100 / RGB may also be cleaned with a damp cloth
and a mild detergent .

7 Specifications

Data protocol: . . . . . . . . . . DMX 512
Number of DMX channels: selectable: 3, 4, 5
Light source: . . . . . . . . . . . RGB COB LED
Power consumption: . . . 100 W
Beam angle: . . . . . . . . . 60°
DMX connections: . . . . . . XLR, 3 poles
Pin assignment: . . . . . . . Pin 1 = ground
Power supply: . . . . . . . . . . 230 V/ 50 Hz
Power consumption: . . . . . 120 VA max .
Protection of housing: . . . . IP 66 (ODC- only)
Dimensions w/o
mounting bracket: . . . . . . ⌀ 185 × 250 mm
Weight: . . . . . . . . . . . . . . 6 .5kg
Subject to technical modification .
or 10
Pin 2 = DMX−
Pin 3 = DMX+
23