Music Control; Show Programmes And Sequences Of Scenes; Programming Sequences Of Scenes - IMG STAGELINE ODC-100/RGB Manual De Instrucciones

= brightness of the colour red
= brightness of the colour green
= brightness of the colour blue
6) Use the button ENTER to select the colours
one after the other, and use the button UP or
DOWN to set their brightness .
7) To select another shade of white or to change
the settings of another storage location, press
the button MENU so that the number of the
storage location is shown again . Then repeat
steps 4 – 6 .
Note: If the spotlight is switched off and on again in this
mode, the spotlight will remain dark and the shade of
white desired or the individual shade of colour will have
to be selected again .

4.1.3 Music control

The spotlight is equipped with a microphone to
support music-controlled colour changes and a
music-controlled stroboscope .
1) Press the button MENU repeatedly until the
highest menu level has been reached .
2) Press the button UP or DOWN repeatedly until
the display indicates
3) Press the button ENTER . The display indicates
the mode most recently selected:
= music-controlled colour change
= music-controlled stroboscope
4) Use the button UP or DOWN to select the
mode desired .
Important: Do not exit the menu item
via the button MENU if the spotlight is to
operate in a music-controlled mode after switch-
off and switch-on .
4.1.4 Show programmes and
sequences of scenes
10 show programmes (
stored in the spotlight . Furthermore, 10 se-
quences of scenes (
30 scenes can be programmed (
The show programmes and sequences of scenes
can be started as follows:
1) Press the button MENU repeatedly until the
highest menu level has been reached .
2) Press the button UP or DOWN repeatedly until
the display indicates
3) Press the button ENTER . The display now in-
dicates the show programme most recently
selected ( ...
.
or
... ) are
... ) with up to
☞ chapter 4 .1 .5) .
.
) or the sequence
of scenes most recently selected (
) .
4) Use the button UP or DOWN to select the
show programme or sequence of scenes de-
sired .

4.1.5 Programming sequences of scenes

10 sequences of scenes can be easily programmed .
A sequence may consist of up to 30 scenes which
is automatically repeated . For each scene, the
colour can be set along with its brightness, the
stroboscope function can be activated with a var-
iable flash rate, and the duration of the scene as
well as the fading time can be defined .
1) Press the button MENU repeatedly until the
highest menu level has been reached .
2) Press the button UP or DOWN repeatedly until
the display indicates
3) Press the button ENTER . The display now
indicates the number of the sequence most
recently changed (
4) Use the button UP or DOWN to select the
number under which the sequence of scenes is
to be stored, and then press the button ENTER .
The display indicates the number of the first
scene ( ) .
5) Press the button ENTER to call up the following
setting functions one after the other:
= brightness of the colour red
= brightness of the colour green (0 – 255)
= brightness of the colour blue
= flash rate (0 – 20) of the stroboscope
= duration of the scene in seconds
= fading time
Use the button UP or DOWN to set the value
desired .
6) After setting the first scene, press the button
MENU . The display indicates the number of the
scene again . Use the button UP to select the
second scene, press ENTER and then select the
settings for this scene . Repeat this procedure
for the following scenes . If not all 30 scenes
are required, enter 0 as the value
numbers of scenes that are not to be used .
...
.
... ) .
(0 – 255)
(0 – 255)
for the
17