Descargar Imprimir esta página

DeWalt DXGNI 2500 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety
GENERAL SAFETY
Always follow National and Local electrical codes pertain-
ing to generators. All local and national codes supersede
rules or information provided in this manual.
REFER TO LOCAL AND NATIONAL
WARNING
ELECTRICAL CODES TO DETER-
MINE GROUNDING REQUIREMENTS AS THIS CAN
VARY PER APPLICATION. THE GENERATOR IS
GROUNDED INTERNALLY NEUTRAL TO FRAME.
WHERE APPLICATIONS REQUIRE EXTERNAL
GROUNDING, A CONNECTION MUST BE MADE
FROM THE GENERATOR TO A SOLID EARTH
GROUND. A CONTINUOUS LENGTH OF SPLICE-
FREE COPPER CABLE, NO SMALLER THAN 6 AWG,
SHALL BE USED FOR THE CONDUCTOR.
When moving or transporting this generator, take proper
precautions to avoid fuel spillage. Further, always use
common sense when lifting this generator. An adequate
number of people and proper lifting methods must be
used.
Do not cover the generator while it is running or immedi-
ately after shutdown. Always allow time to cool down
before covering.
Do not operate this generator unless it is in good mechani-
cal and electrical condition.
Always keep hands, body parts, hair and clothing well
away from the rotating parts of the generator.
Do not start this generator with connected devices turned
"ON". Always make sure that connected devices are dis-
connected from the generator or turned "OFF" before start-
ing the generator.
Generators operating on job or construction sites may be
required to have GFCI (Ground Fault Circuit Interrupters)
receptacles.
Use only grounded extension cords in good condition and
make sure that the wire size within the extension cords is
of sufficient size to safely carry the surge output of the out-
let the cord is plugged into.
Never handle extension cords or electrical circuits if stand-
ing in water or if standing in a damp area.
RISK OF BODILY INJURY
KEEP HANDS, BODY PARTS, HAIR
WARNING
AND CLOTHING AWAY FROM THE
"HOT" PARTS OF THE GENERATOR SET DURING
AND AFTER OPERATION. THE EXHAUST SYSTEM,
AND THE GENERATOR IN GENERAL, CAN REMAIN
VERY HOT EVEN AFTER BEING SHUT DOWN.
ENVIRONMENTAL PROTECTION
INSPECT THE EXHAUST SYSTEM
CAUTION
REGULARLY TO ENSURE IT IS
FUNCTIONING PROPERLY. LEAKY EXHAUST SYS-
TEMS WILL INCREASE NOISE LEVELS.
DIRECT THE "LOUD" SIDES OF THE
CAUTION
GENERATOR INTO OPEN SPACES
AVOIDING REVERBERATION FROM WALLS OR
BUILDINGS THUS AMPLIFYING THE SOUND.
4
NEVER DRAIN OR DISPOSE OF
NOTICE:
ENGINE OIL INTO THE GROUND OR
DOMESTIC WASTE WATER SYSTEMS.
Accessories
Recommended accessories for use with your tool are
available for purchase from your local dealer or autho-
rized service center. If you need assistance in locating
any accessory for your tool, please contact an Authorized
DEWALT Service Center, call 1-888-431-6871 or visit our
website www.dewalt.com.
Service Information
Please have the following information as shown listed on
the data label available for all service calls:
Model No.
Serial No.
Date of Purchase
Place of Purchase
Repairs
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by an
Authorized DEWALT Service Center. Call 1-888-431-
6871. Always use identical replacement parts.
Free Warning Label Replacement
If your warning labels become illegible or are missing,
call 1-888-431-6871 for a free replacement.
Instruction Manual for Portable Generator
Data
Label
013952

Publicidad

loading