Kenmore ULTRA WASH 665.15832 Manual De Uso Y Cuidado página 14

Use this cycle for china
and crystal. This cycle
uses a light wash and
gentle dry. During the
heated dry, the heating
element cycles on and off.
Initial display time: 68 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
Use this cycle for pre-
rinsed or lightly-soiled
loads. The sensor adds
water and time, if needed,
for maximum cleaning.
No drying options are
available for this cycle.
Initial display time: 26 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
Use this rinse cycle for
rinsing dishes, glasses,
and silverware that will
not be washed right away.
Initial display time: 10 min
Soil Wash Rinse Main
Level Wash
Sensed
Heavy
Light
NOTE: The sensor in your dishwasher monitors the soil level.
Cycle time and/or water usage can vary from the numbers above
as the sensor adjusts the cycle for the best wash performance.
14
All manuals and user guides at all-guides.com
Use
covered
detergent
dispenser
section.
Rinse Final Dry Cycle
or Heated Time
Purge Rinse (min)
72*
130°F
cycled
(54°C)
58*
130°F
cycled
(54°C)
Use
covered
detergent
dispenser
section.
Purge Final Dry Cycle
Heated Time
Rinse (min)
30*
140°F
(60°C)
26*
140°F
(60°C)
Do not use
detergent
with this
cycle.
Rinse Final Dry Cycle
Heated Time
Rinse (min)
14
10
Anytime during a cycle, press
Water
The dishwasher pauses for about 5 seconds. Then the
Usage
display shows
(gal/L)
8.6/32.7
4.8/18.2
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light turns
off. Select a new cycle and options.
To stop the drain
You can press Cancel/Drain again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
NOTE: A small amount of water remains in the dishwasher. This
is normal.
To clear the indicators
Water
Press Cancel/Drain before starting the dishwasher to clear all
Usage
options and cycles.
(gal/L)
6.9/26.1
Changing a Cycle or Setting
4.8/18.2
During the first fill of a cycle
1. Press a new cycle and/or options.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
After the first fill of a cycle
1. Press
Water
The display shows
Usage
(gal/L)
4.3/16.4
2.2/8.2
Your dishwasher starts a 2 minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
Canceling a Cycle