BH FITNESS G6508N Manual Del Usuario página 14

GENERAL INSTRUCTIONS
The electronic monitor is designed to
be easy and intuitive to use. The
messages that appear on the bottom
screen (B) will
throughout the whole exercise.
Nevertheless, we recommend that the
gym instructor reads through this
section carefully to become fully
familiar with the electronic monitor in
order to show the user how to operate
it correctly.
NOTE: The monitor will switch back to
stand-by mode after 4 minutes if no
keys are pressed. The monitor can be
switched back to READY by pressing
the STOP key.
PERSONALISING THE
ELECTRONIC MONITOR.-
Follow the procedure below to access
the monitor's personalisation mode:
With the machine and the monitor
switched off, press and hold the
RESET key and turn the main switch
(b) to position 1 Fig. (A), located at the
bottom front of the machine.
1) CHANGING LANGUAGE.-
With the monitor
"LANGUAGE" will appear flashing on
the alphanumeric screen (B), Fig.2.
Press the ENTER key and the current
guide the
Fig.A.
on, the
English
language will start flashing. Select
your language using the UP▲ and
DOWN▼
ENTER, the word "LANGUAGE" will
start
user
DOWN▼ key , pass on to the ( 2
SOUNDS) setting.
2)
With the word "SOUNDS" flashing,
press the ENTER key and the word
ON or OFF will start flashing. Select
the flashing value using the UP▲ and
DOWN▼ keys and then press ENTER
to confirm, the word "SOUNDS" will
start
DOWN▼ key to pass to the (3 Text)
setting.
3)
MESSAGE.-
With the word "TEXT" flashing, press
the ENTER key and the word ON or
OFF will start flashing. Select the
option that is flashing by using the
UP▲ and DOWN▼ keys choosing the
ON option allows you to change the
monitor's welcome message.
Once
selected, press the ENTER key and a
flashing cursor will appear on the
alphanumeric screen (B). Use the
UP▲ and DOWN▼ keys to enter a
welcome message letter by letter.
Once you have finished entering the
message, press the ENTER key for a
few seconds and the word "TEXT" will
start flashing. Use the DOWN▼ key to
word
pass on to the (4 Manual T) setting. If
you wish to exit the personalisation
mode press the STOP key.
14
keys and
flashing again,
CHANGING THE SOUND.-
flashing again,
CHANGING THE WELCOME
the ON option
then press
using the
using the
has been