TREVIDEA Girmi ST61 Manual Del Usuario página 13

The iron must be used and rested on a stable surface. Do
not use the ironing system as a heating unit.
Always unplug the appliance before you fill or empty the
tank.
Do not fill the tank above the maximum capacity and do
not introduce into the tank mixtures for removing stain,
vinegar, descaling agents or chemicals in general.
Always select the most suitable temperature according to
the fabric to be ironed.
When placing the iron on its iron stand, make sure that
the surface is stable.
Iron should not be used if dropped, if there are visible
signs of damage, if it loses water during operations.
CAUTION: the iron plate gets very hot during use, be
careful not to touch it, serious risk of burns. Do not
put your face near the steam coming out the iron plate
MOD. ST61
1) Spray nozzle
4) Steam button
7) Power cord
9) Base
11) Water tank
FILLING THE TANK
The filling operation must be performed only when the plate has been cooled down and after having
unplugged the unit from the electrical outlet. We recommend the use of demineralized water to prevent
excessive fouling (not covered by warranty).
Place the steam control knob (3) on "0". Open the water tank lid (2).
1)
2) Raise the tip of the iron to avoid any leak of water during the operation.
3) Enter the water up to the maximum level indicated with "MAX" on the tank (11). Close the lid (2).
TEMPERATURE SETTING
The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
•
It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since the ironing plate heats faster than it cools down.
When you do not know the composition, it is recommended to iron a non-visible part of the it, starting
from the lowest temperature to find the most suitable temperature.
•
Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate
and the fabric.
2) Water fill opening
5) Spray button
8) "Soleplate temperature" indicator light.
10) Soleplate Temperature Selector Dial
12) Soleplate
3) Steam adjustment button
6) Handle
13) Self-clean button
12