Descargar Imprimir esta página

Amica 10143.4eETsDpHaQaXSp Manual De Instrucciones página 44

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
Electronic programmer*
- select the mode of operation
MENU
>
- higher setting sensor
<
- lower setting sensor
- appliance on indicator
- kitchen timer
- Duration
Setting the time
After connection to the mains or reconnection
after a power cut the display shows flash 0.00
l Touch and hold
touch < and >) until you will see
display and the dot below the symbol is
flashing,
l Touch < or > within 7 seconds to set the
current time.
To store the new time setting, wait approxi-
mately 7 seconds after time has been set.
The dot below the
You can adjust the time later. To do this touch
< and >, simultaneously and adjust the cur-
rent time while the dot below the
is flashing.
Caution!
If the correct time is not set then proper opera-
tion of the oven is not possible.
*optional
(or simultaneously
MENU
on the
symbol will stop flashing.
symbol
Timer
The timer can be activated at any time, re-
gardless of the status of other functions. The
timer can be set for from 1 minute to up to 23
hours and 59 minutes.
To set the timer you should:
l Press sensor
show flashing
l set the timer using sensors > and <.
The time set is shown on the display and
the signal function
l Press sensor
switch off the signal, the signal function
will go out and the display will show the
current time.
Caution!
If the alarm signal is not turned off manually,
it will be turned off automatically after approx.
7 minutes.
Semi–automatic operation
If the oven is to be switched off at a given
time, then you should:
l Set the oven function knob and the tem-
perature regulator knob to the setting at
which you want the oven to operate.
l Press sensor
show:
lSet the required time using sensors < and
>, within a range from 1 minute to 10 hours.
The set time will be introduced to the memory
after approx. 7 seconds and the display will
show AUTO function.
When the set time has passed the oven is
switched off automatically, the alarm signal
is activated and the signal function AUTO
flashing again;
44
, then the display will
MENU
,
is on.
< or > in order to
,
MENU
until the display will
MENU

Publicidad

loading

Este manual también es adecuado para:

10143.4eetsdphajvqaw