Descargar Imprimir esta página

BH FITNESS H6975 Instrucciones De Montaje Y Utilización página 11

Ocultar thumbs Ver también para H6975:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Take the guard (23) and insert it as
shown in Fig.7. Take handle (25) and
spacer (24) and screw it clockwise
onto the bottom hole, Fig.7.
7 ADJUSTING SADDLE
HEIGHT.-
Loosen the saddle post knob (42) a
little, turning it anticlockwise, and pull
it back, Fig.7, adjust the height of the
saddle to suit the exercise and then
release the knob so that it slots back
into one of the holes on the saddle
post. Tighten the knob (42) securely
by turning it clockwise.
8 FITTING THE ELECTRONIC
MONITOR.-
Undo screws (4) located at the back of
the monitor,
sticking out of the top of the main post
(6), into connector (n), located at the
back of the monitor (1) Fig.8. Take the
end of the hand-grip cable (z) and
insert it into connector (v) at the back
of the monitor, Fig.8. Now slide the
monitor onto the plate at the top of the
main post (6) Fig.8, put the two
screws (4) back in and tighten.
9 ADJUSTING THE
HANDLEBAR.-
Set the handlebar (2) so that you can
pedal in a comfortable position and,
without
releasing
tighten up handle (25) securely, Fig.9.
10 LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
connect cable (49),
the
handlebar,
can be achieved by screwing the
adjustable feet (64) up or down, as
shown in Fig.10.
11 MOVEMENT & STORAGE.-
The unit is equipped with wheels (56)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.11. Store your unit in a dry place,
preferably not subject to changes in
temperature.
12 MAINS CONNECTION.-
Insert the jack (c) on the transformer
into the connection hole (h) on the
main body (17) (bottom, rear of the
machine)
transformer (73) into a 220V mains
supply, Fig.12.
(Mod H698)
Note:
The
necessary to charge the battery after
long periods of inactivity. Disconnect
the transformer before using the
machine.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
Do not hesitate to get touch with us if
you have any queries, by calling:
+44 0844 335 3988
service@bh-uk.co.uk
11
and
then
plug
transformer
the
is
only

Publicidad

loading

Este manual también es adecuado para:

H698