Other; Messages Relating To Bd Disc And Dvd Disc; To Reset This Player; Keylock Function - Yamaha BD-S1900 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

■ Other

Problem
The TV operates incorrectly.
The Player heats up during use.

■ Messages Relating to BD disc and DVD disc

– The following messages appear on the TV screen in case the disc you tried to playback is not appropriate or the
operation is not correct.
Error message
Cannot play.
Incompatible disc.
Cannot operate.
This USB memory is not formatted
properly. Please format the memory in
USB memory management.
The Connected USB Memory cannot
be used. It should be compliant with
USB 2.0

To Reset this Player

If this Player receives strong interference from a source such as excessive static electricity, strong external noise,
malfunction of power supply, or voltage caused by lightning during use or a wrong operation is sent to the Player, errors
like the Player not accepting an operation may occur.
1 Press and hold p on the Player until "RESET" appears on the front panel display when the Player does not operate
properly even after the power has been turned off.
2 Turn on the power.
Notes
– When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it
may take a few moments for the system processing to finish before the Player is ready for use.
– When the problem persists even after performing a reset, unplug the power cable and plug it in again. If this does
not solve the problem, contact the nearest service center approved by Yamaha.

Keylock function

You can set the keylock to prevent accidental operations. Press and hold
than 4 seconds while no disc is inserted in this Player and the disc tray is closed.
– Each time you perform this operation, the function is activated or deactivated.
– If you try to operate the Player while the keylock function is set, "Lock" blinks on the front panel display to indicate
that the keylock function is set.
Possible causes and solutions
– Some TVs with wireless remote control capability may operate incorrectly when using
the remote control of this Player. Use such TVs away from this Player.
– When using this Player, the console cabinet may heat up depending on the usage
environment. This is not a malfunction.
Possible Error
– The disc cannot be played back with this Player.
– If you load a disc which cannot be played with
this Player (i.e. a scratched disc), or if you load
a disc upside down, this message will appear,
and the disc tray will automatically pop out.
– Occurs if the loaded disc cannot be played
because it is a non-standard disc or scratched,
etc.
– Occurs if an operation is incorrect.
– Occurs if there is a formatting error.
– Occurs if the USB memory is not formatted
with FAT 32/16.
– Occurs if USB memory not compliant with
USB 2.0 High Speed (480Mbit/s) is used (i.e.
USB 1.0/USB 1.1).
Possible Error
– Check the disc, and load it correctly.
– Remove the disc.
– Format the USB memory again.
– Format the USB memory with your
PC.
– Connect USB 2.0 High Speed
(480Mbit/s) compliant USB
memory.
and
on the front panel for more
Troubleshooting
5
41
En

Publicidad

Tabla de contenido
loading

Tabla de contenido