Descargar Imprimir esta página

Kasanova MGG000009NOC Manual De Instrucciones página 14

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MILK FROTHER
14
continuously, the working indicator will flash and the switch button will not be activated, after about
5 minutes, the appliance will enter standby state and you can continue operating the appliance.
NOTE:Please clean the jar according to the section "CLEANING AND MAINTENANCE" between
two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.
II. Warm and thin foam
1.Place the appliance on a flat surface.
2.Then open the lid, insert the frothing paddle onto the shaft on the bottom of jar.
3.Fill the jar with the desired amount of milk, and replace the lid.
NOTE: The max milk quantity permitted to add is 150ml(see Fig. 1), to avoid milk overflowing after
frothing.The min milk quantity permitted to add is 75ml.
NOTE: Please use whole milk, not cold milk (5-10°C).
4.Connect the plug into a power outlet.
5.Press the FUNCTION button twice, the working indicator of "Warm and thin foam" will light up.
Then press the ON/OFF button once,the appliance will start to work. Once the temperature of milk
has achieved the setting value, appliance will stop working;
Note: During operation, you can stop operating by pressing the ON/OFF button once.
6. When the appliance has stopped operating, open the lid, pour out the warmed and frothed milk
to enjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two continuous cycles,
otherwise, the appliance will enter self-protection state automatically after working for 5 cycles
continuously, the working indicator will flash and the switch button will not be activated, after about
5 minutes, the appliance will enter standby state and you can continue operating the appliance.
NOTE:Please clean the jar according to the section "CLEANING AND MAINTENANCE" between
two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.
III. Only warming separately, without frothing
1. Place the appliance on a flat surface.
2. Then open the lid, insert the frothing paddle onto the shaft on the bottom of jar.
3. Fill the jar with the desired amount of milk, and replace the lid.
NOTE: The max milk quantity permitted to add is 300ml(see Fig. 1), to avoid milk overflowing after
mixing. The min milk quantity permitted to add is 75ml.
NOTE: Please use whole milk, not cold milk (5-10°C).
4. Connect the plug into a power outlet.
5. Press the FUNCTION button three times, the working indicator of "Only warming separately,
without frothing" will light up. Then press the ON/OFF button once,the appliance will start to work.
Once the temperature of milk has achieved the setting value, appliance will stop working;
6. When the appliance has stopped operating, open the lid, pour out the warm milk and enjoy it.
Caution: Minimum 3 minutes rest time must be maintained between two continuous cycles,
otherwise, the appliance will enter self-protection state automatically after working for 5 cycles
continuously, the working indicator will flash and the switch button will not be activated, after about
5 minutes, the appliance will enter standby state and you can continue operating the appliance.
NOTE:Please clean the jar according to the section "CLEANING AND MAINTENANCE" between
two continuous cycles.
7. Always turn off the milk frother and disconnect the power supply when not use.

Publicidad

loading