Domo DO1051K Manual De Instrucciones página 35

Idiomas disponibles

channel and drainage hole at the back of the appliance clean.

Store raw meat and fish in suitable containers in the refrigerator so that they do not come

into contact with or drip onto other food.

If the appliance is left empty for longer periods, it should be turned off, defrosted and

cleaned. Allow it dry and leave the door ajar to prevent mould from growing in the appliance.

WARNING! Never place this appliance on or in the neighbourhood of a gas or electric fire

or in a place where it could come into contact with a heat source. There are flammable

materials located on the back of the appliance.

Pay attention to the symbol 'Fire risk – flammable materials' located on the back of the

appliance.

PARTS

Temperature control knob

Shelves

Vegetable container

Levelling feet

Door shelves

BEFORE THE FIRST USE

Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the

inside with a wet, lukewarm cloth.

Select a place with a strong, level floor.

Allow 13 cm of space between the back of the refrigerator and any adjacent wall.

Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will

cause higher electricity consumption.

Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the

evaporator, and your refrigerator.

Before connecting your refrigerator to the power supply, check that the voltage stated on the rating

label of your appliance corresponds to the voltage in your home. A different voltage could damage the

appliance.

After installation, leave the freezer for 8 hours before turning it on. This way the refrigerant can settle.

Allow the appliance to run empty for 24 hours so the compartment can cool to the appropriate

temperature.

www.domo-elektro.be

DO1051K