Publicidad
Idiomas disponibles
Idiomas disponibles
4. Power tool use and care
a. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do
the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or the battery pack from the power tool before making any
adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk
of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or
these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users.
e. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other
condition that may affect the power tool's operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely
to bind and are easier to control.
g. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account
the working conditions and the work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
5. Service
Have your power tool serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
ROUTER SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces when performing an operation where cutting tool may contact
hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and
shock the operator.
2. Use clamps or another practical way to secure and support the work piece to a stable platform. Holding the
work by hand or against your body leaves it unstable and may lead to loss of control.
3. Use only accessories rated at least equal to maximum speed marked on Router.
4. Only use router bits with a shank diameter equal to the size of the tool's collet. The collet size is adjustable
for 1/4", 3/8" or 1/2".
5. Make sure the collet nut is securely tightened before use to prevent the router bit from slipping during use.
6. Do not use with base removed.
7. Hold router with both hands.
8. Keep hands away from the cutting area. Do not place hands beneath the workpiece for any reason. Keep
the base of the router in firm contact with the workpiece while cutting.
9. Keep Handles dry, clean, and free of oil or grease. This will permit better control of the tool.
10. Do not use damaged bits.
11. Do not lay the Router down until it has stopped rotating completely.
12. Hold the Router firmly when starting, as startup rotation creates significant torque.
13. Hold the Router firmly while cutting. The action of the bit against the workpiece can cause it to "kick out",
jumping rapidly away from the workpiece. This can be caused by an improper type of bit, or a dull bit.
14. Do not handle the Router bit immediately after cutting. It may be very hot, potentially causing burns or
injury.
15. Avoid overloading the tool. If the speed drops abnormally, decrease the pressure on the bit immediately.
Do not apply excessive pressure to the router while cutting.
16. Always use sharpened bits. If the bit stops abruptly, or the bit becomes blocked, remove the Router from
the workpiece and shut it off.
17. Do not start the Router while the bit is in contact with the workpiece. Allow the tool to reach its normal
operating speed before applying the bit to the workpiece.
3
Keep Working
Publicidad
