Publicidad
Idiomas disponibles
Idiomas disponibles
1. Hold the Router handles firmly with both hands.
2. Place the Router directly above the point you plan to cut. Verify that there are no obstructions in the cutting path.
3. Turn on the Router.
4. Before cutting material, watch and feel for vibration which could indicate an improperly installed bit. Turn off
and re-install bit, if needed.
5. Allow the bit to come to full speed, slowly engage material. DO NOT force the Router down into the material.
6. When finished, raise the Router so the bit is clear of the material, then turn the Power Switch off. Do not set
the Router down until the bit has come to a complete stop.
7. Do not touch the bit right after cutting. It becomes very hot. Allow to cool before changing bits.
8. Do not leave the router running when not actually cutting. Turn power off between cuts.
9. To prevent accidents, disconnect the power supply after use. Clean, then store the tool indoors out of
children's reach.
MAINTENANCE AND SERVICING
Procedures not specifically explained in this manual must be performed only by a qualified
technician.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general condition of the tool. Check for loose hardware, misalignment or
binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that
may affect its safe operation.
2. After Use, wipe external surfaces of the tool with clean cloth.
3. Regularly clean all ventilation openings by periodically brushing with a soft brush and/ or blowing clear with
compressed air.
4. WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service
technician.
Replacing Carbon Brushes
Remove and check the Carbon Brushes regularly. Replace when they wear down to
the limit mark on the carbon. Replace both brushes at the same time. To replace:
Remove the Brush Caps and old brushes, then insert the new brushes and secure
the caps in place.
Limit mark
www.ELITETOOLS.co
Keep Working
Brush
Cap
(15)
Carbon
Brush
(18)
12
Publicidad
