Publicidad
Idiomas disponibles
Idiomas disponibles
3. Slide the Scale Ring until the "0" aligns with the index
line (vertical mark) on the Main Housing. Unlock the
Lock Lever. Each line on the scale raises or lowers
the bit by 1/64".
Attaching Guide
To attach the Guide (24) when making straight cuts:
1. Loosen the four Wing Nuts (27 and 37).
2. Slide the Guide Poles (28) on the Guide (24) into
the slots on the Base of the Router with the Guide
facing the workpiece.
3. Adjust the distance between the router bit and the
Guide to the desired setting.
4. Tighten the Wing Nuts (27 and 37).
Work Piece and Work Area Set Up
1. Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to
prevent distraction and injury.
2. Route the power cord along a safe route to reach the work area without creating a tripping hazard or
exposing the power cord to possible damage. The power cord must reach the work area with enough extra
length to allow free movement while working.
3. Secure loose work pieces using a vise or clamps (not included) to prevent movement while working.
4. Make sure there are no metal objects in the wood which might make contact with the router bit.
Index Line
(vertical mark on
Main Housing)
Scale Ring
4. While holding the Base up from the surface, rotate
the Main Housing to raise or lower the bit until the
index line on the housing aligns with the desired
depth on the scale ring. Lock the Lock Lever.
Lock Lever
(30)
Guide (24)
Wing Nuts (27)
www.ELITETOOLS.co
Wing
Nuts (37)
Base
(45)
Guide Poles (28)
10
Keep Working
Publicidad
