Publicidad
Idiomas disponibles
Idiomas disponibles
General Operating Instructions
Note: Use two or more passes for deep cuts, especially in the case of hardwood. Do not attempt to cut deeper
than 5/8" in a single pass. Adjust the cutting depth so that the first pass will be less than 5/8" deep, then follow
the procedures for Adjusting the Cutting Depth for each progressive pass, until the final depth is achieved.
Note: Feed the Router bit into the workpiece against the bit's direction of rotation.
When cutting outside edges, guide the router counterclockwise around the workpiece. Move it clockwise
when cutting inside edges.
WARNING! Moving the router against the recommended direction can cause serious injury from kickback.
Note: Make practice cuts at different speeds in scrap material until you are able to produce a smooth cut with
no burnishing or burn marks. Burn marks are caused by moving too slowly through the wood. Feeding the
Router too quickly, or trying to remove too much material in a single pass creates a rough cut and can
overload the motor.
WARNING! When first turning on the Router, grip the Handles firmly as the tool may try to twist from the strong
initial torque.
View from top of piece
Bit revolving direction
Feed direction
View from cutting edge of piece
Bit revolving direction
Router
Direction
Feed direction
www.ELITETOOLS.co
11
Keep Working
Publicidad
